Hot tub electrical installation is easy with the appropriate setting. Based on the size of the basin, may be 120 volt or 240 volt unit. 120 volts can be smaller than 20 thousand units simply be plugged into the pot, where the larger units will require full electrical installations. In this guide you will learn how to install 240 volt hot tub on the outside board with a wire above the ground.
Material
* Hot Tub
* Spa Package (GFCI protection team)
* # 6 THHN stranded copper wires
* Two pole circuit breakers Amp (2P50)
* Color Coded Tape
* Table 80 channel plastic
* Electrical Tape
Hats wire *
Step 1 – put the hot tub
Put a hot tub on the cement board in the desired location. Before you begin, make sure that the house main electrical panel is easily accessible from this site. If it is present in the panel on the other side of the house may want to consider in the operation of underground electric or change the status of the hot tub.
Step 2 – Preparation of Wires
Measure the length of the main electrical panel of the package and then the length of Spa package of Spa hot tub. Keep in mind that the package must be placed closer Spa no more than five feet from your hot tub. You will need to make sure they are still in the location of your unit. There can be no obstacles such as fences or walls, and prevent access to the Spa package. Once the measurement, and add to the feet. The surplus will allow for any error in the measurement, and can be cut in the final steps. Cut four pieces of copper wire stranded, which is labeled # 6 THHN for each measurement. Wrap about 3 feet on each end of wire with color coded bar in black, red, green and white. When you are finished
you must be one of each color along the motherboard and the package of spa, as well as the length of a package of spa hot tub.
Step 3 – Run the wires
Start with two pieces of the table 80 channel poly vinyl chloride, one for each length of wire. Run the wire through the channel marked plastic. Attach the wires to the Control Panel hot tub, even match the color coding. Bar the use of electrical wiring and caps to secure them. Run the other end of this set of wires to the Spa package, connect the wiring in the palace itself. Do the same for the second set of wires, attached to the other side of a package of Spa. At this point, start filling your hot tub with water. Once you have the will power you will need to start the tub to heat the water and the preparation of the aircraft.
Step 4 – Installation of Breaker
Install two pole breaker in the 50 amp your main electrical service panel. Follow the direction of the manufacturer to install a safe and correct. Attach another set of wires to the breaker. Connect the green and white bar to the ground. Make sure that the linked black and red on the actual wave.
Step 5 – start in the hot tub
Once you fill the tub with water, you will need to get the main breaker to run a spa and hot tub. It may take several hours to a hot tub to heat up. Use this time to identify the features and operation of your hot tub.
http://www.prohometips.com/ This site facilitate with home improvement,home repair,extreme home makeover,home improvement site,HGTV,DIY,do-it-yourself,buying guides,consumer reports ,Free home improvement advice, great remodeling tips, and appliance buying guides by leading home improvement authority, DIY expert and HGTV personalityFor furhter details about hot tub electrical installation visit our website: http://www.prohometips.com/
Article Source